PolyLens MSI Configuration

[Jesqueda1]

Hello, 

We are trying to push poly lens  app to all of the users in our firm. We run a Microsoft Intune image and are hoping to silently install this app to everyone. However, our desktop engineer is not seeing a way for them to not have to accept the EULA. Is there a step we are missing or a flag we are missing to auto except this, and auto launch the app? 

Here is some communication from him. 

These are the following cmd line parameters I’m using:  TENANTTOKEN=”OURID” ACCEPTEULA=0

Source - HP Poly Studio Desktop - Loginless | Poly Lens and StudioHelp

Every install I’ve done the EULA has to be accepted and the end user has to manually walk through logging in with their credentials.

The end user check and accept his.  The above parameter for the EULA does not accept this for the user, but accepts it for the device for the application to auto start.  If you omit that parameter or set it to 1, the application does not auto start until the end user manually opens it and accepts this.  This prompt must be accepted by the end user unless there is some sort of flag that is not documented by HP.

[M_Salman]

Hello @Jesqueda1, Welcome to the HP Poly Support Community.

Thanks for reaching out about your query regarding the Poly device.

It looks like this may need direct support from our technical team. I encourage you to contact HP Support, where our engineers can take a closer look and help sort it out. You’ll find the contact link below.
https://support.hp.com/us-en/poly

Take care and have an amazing day!

If you would like to thank us for our efforts to help you, go to the public post and give us a virtual high-five by clicking on "Yes" for the question "Was this reply helpful?" below my message, followed by clicking on the "Accept as solution" on my public post.

Regards,

Salman