Admin Password

[JorgenB1]

How can I reset LaserJet MFP M234sdw admin password?

[Raj_05]

Hi @JorgenB1,

Welcome to HP Support Community.  

Thank you for posting your query, I will be glad to help you.

Resetting the admin password on an HP LaserJet MFP M234sdw printer typically involves a few steps. Please note that this process may vary slightly depending on the firmware version of your printer. Here are the general steps to reset the admin password:

1. Access the Printer's Web Interface:

• Connect your computer or device to the same network as your printer.
• Open a web browser (e.g., Chrome, Firefox, or Edge).
• Enter the IP address of your HP LaserJet MFP M234sdw in the browser's address bar. You can usually find this information on the printer's control panel or through a network status page.
• Press Enter to access the printer's web interface.

2. Log in to the Printer's Web Interface:

• You will be prompted to enter a username and password. By default, the username is usually "admin," and the password is often left blank or set to "admin." Try these credentials first. If they don't work, consult your printer's documentation for the default login information, or contact your printer's manufacturer for assistance.

3. Reset the Admin Password:

• Once logged in, navigate to the security or settings section of the printer's web interface.
• Look for an option to reset or change the administrator password. This option may be labeled "Change Password," "Security," or something similar.
• Follow the on-screen instructions to reset the password. You will typically be asked to enter the old password (which may be blank if it's the default), and then create a new password.

4. Save Changes:

• After you've set the new password, make sure to save or apply the changes.

5. Test the New Password:

• Log out of the printer's web interface and then log back in using the new administrator password to ensure it's working correctly.

If you cannot reset the admin password using the web interface or if you've forgotten the printer's IP address, you may need to perform a factory reset on the printer, which will erase all custom settings, including the password. 

Remember that resetting the admin password will also remove any security configurations or custom settings you've applied to the printer, so be sure to document these settings before performing the reset.

I hope this helps. 
 

Take care and have a good day.

Please click “Accepted Solution” if you feel my post solved your issue, it will help others find the solution. Click the “Kudos/Thumbs Up" on the bottom right to say “Thanks” for helping!

Alden4
HP Support