HOW DO I GET MY WPS PIN???

[erwsa]

HOW DO I GET MY WPS PIN???   Nothing shows on the screen nothing is printed I'm not sure if I'm feeding the paper correctly and no I cannot connect through the usual smart app.  

WT****   did you make wireless setup so god **** complicated?

[Mans · Accepted solution]

@erwsa 

Hello,

Please restart the printer, computer, and router for solve this problem.

1. Turn the printer off, and then wait 10 seconds.
2. Disconnect the printer power cord from the printer.
3. Turn off the computer or the device you are trying to print from.
4. Connect the printer power cord to the printer, and then turn on the printer.
5. Disconnect the power cord from your wireless router, and then wait 30 seconds.
6. Reconnect the power cord to the router.

    NOTE: 
   

   Wait until internet service is restored. Internet service is interrupted while the router is off.

7. Wait at least 3 minutes, then turn on the computer.
8. Proceed to the following steps to connect your printer to the wireless network.

Then try to install it over Wi-Fi by doing the following:

Press a series of buttons on the printer to reset the wireless settings to ensure a successful connection.

1. Go to Devices and Printer to delete your printer icon.
2. Make sure the printer is on.
3. If the wireless indicator light is flashing, go to the next step to continue the software installation.
4. Press and hold down the Power button ().
5. While holding down the power button, press the Start Black Copy button () two times, and then press the Cancel button () three times.
6. Release the power button. The Wireless light next to the Wireless button should be flashing. Repeat these steps if the Wireless indicator does not blink.
7. Proceed immediately to the next step to continue the software installation. You have approximately 20 minutes to complete the software setup using the HP Auto Wireless Connect feature.
8. Launch the printer software installed on the desktop and click Connect a new printer.
9. Follow these steps to set up your wireless connection when the HP Automatic Wireless Connection screen appears:
   • Select Yes, send my wireless settings to the printer, and then click Next.
   • Follow the on-screen instructions to complete the software installation and wireless network setup for the printer.

Please use them HP DeskJet 2600 series Full Software and Driver to install the printer.

I remain at your disposal in case of need.

Best regards,