HP LaserJet Tank 2504dw

[Spettty77]

I recently purchased and installed the above printer. For one week i had not issue connecting to the printer through a Netgear Modem.  I am now trying to connect and I am getting a "Printer offline" message and can not connect.  Need help trying to correct issue.

[Anand_Andy]

Hi @Spettty77,

Welcome to the HP Support Community

I understand you are facing a connectivity issue with your HP Printer. Not to worry I will help you to get a resolution to resolve the issue.

To assist you better:

• Is the blue Wi-Fi light solid on the printer? ( if the Wi-Fi Light is blinking then please re-connect the printer back to your Wi-Fi router - Restore Wi-Fi setup mode on your HP printer, Once you restore the network to defaults, then please follow the instructions on this link to connect the printer back to your PC.)
• How far is the printer located from the WiFi router?
• Do you have a dual-band router?
• If you have a Dual-band router and both 2.4GHz and 5GHz networks share the same name/SSID, the printer will not be able to connect to the network. In this case, contact your Internet service provider to assign different names to both networks.

While you respond to that, Let's perform a power drain: 

• With the printer turned on, disconnect the power cord from the rear of the printer and also unplug the power cord from the wall outlet.
• Remove USB cable, if present.
• Wait for 2-3 minutes, press and hold the power button on your printer for about 30 seconds to remove any additional charge.
• Now plug back the power cable straight to a wall outlet without any surge protector or an extension cord (This is important) and then plug back the power cord to the printer.
• Turn on the printer and wait till warm-up period finishes and the printer is idle

Update the printer firmware 

• Click here to download and install the latest printer firmware from your product
• Click here to know different methods of updating printer firmware.

If the issue persists, then please follow the below steps to resolve the issue.

Set a manual IP-

To set a manual IP and try the steps below:

• Touch on the wifi icon ((i)) on the printer, and take down the IP address 
• Open a web browser (ex Chrome or Mozilla) and type in the printer's IP
• then go to network ---> general ---> network protocols ---> select IPV4 only-->apply 
• go to wireless ---> wireless 802.11---> select manual ip ---> apply
• Enter 8.8.8.8 for the first DNS and 8.8.4.4 for the second DNS.  
• then go to settings on the main ews page --> power management ---> select sleep mode to max 15min

Hope this helps! Keep me posted. 

Please click “Accept as Solution” if you feel my post solved your issue, it will help others find the solution. Click the “Yes" on the bottom right to say “Thanks” for helping