• ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines
Here is the solution to configure HP FutureSmart Printers with Kiwi Syslog Server Click here to view the instructions!
Check some of the most frequent questions about Instant Ink: HP INSTANT INK, HP+ PLANS: INK AND TONER.


Check out our WINDOWS 11 Support Center info about: OPTIMIZATION, KNOWN ISSUES, FAQs AND MORE.
Locked

‎10-08-2018 12:42 PM

HP Recommended
Operating System: Microsoft Windows 7 (64-bit)

Hello,

this is the first printer with the duplex unit I had in my life.

How can I enable the automatic duplex function ?

In the printer software I cannot find any setting about the duplex.

Actually when I print a document made by more than one page, the printer uses only one layer of each sheet.

 

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions

‎10-08-2018 12:54 PM

HP Recommended

@damu999

 

By default it should print duplex automatically. Please try from your computer

 

Enter the Control Panel > Devices and Printers.
Right click the printer icon, then click Printer Properties.
Click the Device Settings tab.
Set the Automatic Two-Sided Duplex Accessory as installed and click OK to save the change.

Now Automatic Duplexing should become available.

 

Regards.

BH
***
**Click the KUDOS thumb up on the left to say 'Thanks'**
Make it easier for other people to find solutions by marking a Reply 'Accept as Solution' if it solves your problem.




View solution in original post

1 person found this reply helpful
Was this reply helpful? Yes No
1 REPLY 1

‎10-08-2018 12:54 PM

HP Recommended

@damu999

 

By default it should print duplex automatically. Please try from your computer

 

Enter the Control Panel > Devices and Printers.
Right click the printer icon, then click Printer Properties.
Click the Device Settings tab.
Set the Automatic Two-Sided Duplex Accessory as installed and click OK to save the change.

Now Automatic Duplexing should become available.

 

Regards.

BH
***
**Click the KUDOS thumb up on the left to say 'Thanks'**
Make it easier for other people to find solutions by marking a Reply 'Accept as Solution' if it solves your problem.




1 person found this reply helpful
Was this reply helpful? Yes No
Warning
Be alert for scammers posting fake support phone numbers and/or email addresses on the community.
If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.
Didn't find what you were looking for? Ask the community
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.