I have HP Envy 5660 with unexpected configuration problem 0x80004005,

[Munjack8633]

I have powered down printer and removed the ink cartridges and then deleted printer from laptop and reinstalled. all drivers and firmware are updated. any suggestions?

[Riddle_Decipher]

@Munjack8633 You seem to have done all relevant steps, however, you could also attempt a hard reset using the below steps:

In some cases, removing the ink cartridges and resetting the printer can clear the error message.

1. Turn on the printer.

2. Wait until the printer is idle and silent before you continue.

3. Disconnect the USB cable from the rear of the printer. If your printer has a network or wireless connection, leave it connected.

4. Remove the ink cartridges from the printer.

5. With the printer turned on, disconnect the power cord from the rear of the printer and from the wall outlet or power strip.

6. Wait at least 60 seconds.

7. Plug the power cord back into the wall outlet.

   NOTE: 

   HP recommends connecting the printer power cord directly to a wall outlet.

8. Reconnect the power cord to the rear of the printer.

9. Turn on the printer, if it does not automatically turn on.

   The printer might go through a warm-up period. The printer lights might flash, and the carriage might move.

10. Wait until the warm-up period finishes and your printer is idle and silent before you proceed.

11. Reinsert the ink cartridges, and then close the ink cartridge access door.

12. If you receive a prompt to print a calibration page, do so.

13. If you disconnected the USB cable, reconnect it to the rear of the printer.

14. Try to print.

If the issue persists, this could be a hardware malfunction, I suggest you talk to HP support and discuss your options:

follow the below steps to get started:

1) Click on this link - www.hp.com/contacthp/

2) Click on "Continue as guest".

3) Enter the serial of your device.

4) Select the country from the drop-down.

5) Click on "Show Options".

Fill the web-form, to populate a case number and phone number for yourself!

Also, if you are having trouble navigating through the above options, it's most likely because the device is out of warranty, is yes? please send me a private message with the region you are contacting us from, 

here's how private messages work: Click here for details.