MFG Mode

[James_ZPI]

How do I get my printer out of MFG Mode?

[Kuroi_Kenshi]

Hi @James_ZPI,

Welcome to the HP Support Community!

Thanks for reaching out!

We're thrilled to have the opportunity to assist you and provide a solution.

I understand your printer is stuck in MFG mode. Let’s go through a few checks.

Power reset

Turn the printer on.

Disconnect the power cord from the rear of the printer.

Unplug the power cord from the wall outlet.

Wait 60 seconds, then reconnect the power cord directly to a wall outlet.

Turn the printer back on.

Restore factory defaults from the control panel

On the printer control panel, open Setup or Settings.

Select Printer Maintenance or Tools.

Tap Restore or Restore Factory Defaults.

Confirm the reset and allow the printer to restart.

Exit MFG Mode from the service menu

From the Home screen, touch the Back button four times quickly.

Open the Support Menu.

Select the Resets Menu.

Tap Manufacturing Mode Off or Exit MFG Mode.

Restart the printer.

Update printer firmware

Load paper into the input tray.

Open Setup or Settings on the printer control panel.

Select Printer Update or Web Services Update.

Install any available firmware updates.

Restart the printer after the update completes.

Please refer to one of our previous posts made by @Jeet_singh  that has assisted other customers with the same issue.

https://h30434.www3.hp.com/t5/Printers-Archive-Read-Only/stuck-in-MFG-MODE/td-p/6868999

I hope this helps.

I'm glad I could help! 😊 If this resolved your issue, please mark it as "Accepted Solution" and click "Yes" on "Was this reply helpful?" Your feedback not only keeps us going but also helps others find the solution faster! 👍✨

Take care and have an amazing day ahead! 🚀

Best regards,