Printer will not go further than "Initializing"

[WindowsByGrace]

My Printer will not go past the "Initializing" stage

[Roopa-S]

@WindowsByGrace
Thank you for being a part of HP Forums,

It’ll be an honor to guide you through the steps needed to identify your concern and/or address your query.
 

I understand you need support and I'll be glad to help you out. However, for an accurate solution I'll need the printer model.

For instruction on how to find the Printer model : Click here

(Ensure you do not share any of your personal information such as serial, phone number, email ID, etc.)

Meanwhile, try printer reset:
Turn on the printer.
Wait until the printer is idle and silent before you continue.
Disconnect the USB cable from the rear of the printer. If your printer has a network or wireless connection, leave it connected.
Remove the ink cartridges from the printer.
With the printer turned on, disconnect the power cord from the rear of the printer and from the wall outlet or power strip.
Wait at least 60 seconds.
Plug the power cord back into the wall outlet.
   NOTE: HP recommends connecting the printer power cord directly to a wall outlet.
 Reconnect the power cord to the rear of the printer.
Turn on the printer, if it does not automatically turn on.
The printer might go through a warm-up period. The printer lights might flash, and the carriage might move.
Wait until the warm-up period finishes and your printer is idle and silent before you proceed.
Reinsert the ink cartridges, and then close the ink cartridge access door.
If you receive a prompt to print a calibration page, do so.
If you disconnected the USB cable, reconnect it to the rear of the printer.
Try to print.

Please click “Accept as Solution” if you feel my post solved your issue, it will help others find the solution.

Click the “Kudos, Thumbs Up" on the bottom right to say “Thanks” for helping!