Unable to assign IP Address to HP LaserJet 2200 DTN using the Cold Reset Process

[Cahr_1]

My printer was working fine until I fixed the high pitched squeal by adding a drop of oil to the scanner motor (after watching a YouTube video).  I put the printer back together and successfully printed the engine-test page (the one with all of the lines on it).  When I went to print, nothing printed.  Pressing the Go and Cancel buttons at the same time, only produces the first page of the Configuration sheet so it seemed to lose its IP Address. However, now, I am unable to assign the IP address to it using the cold reset process.  I am following the instructions to turn the printer off, pressing and holding the Go switch until the Attention light is lit, but now, I get no Attention light at all. Instead, I get the Ready and Go lights lit at the same time.   Even if I remove the toner cartridge, I still get no Attention light.   Can anyone tell me what the issue is?  I love this printer!

Thanks,

Cahr_1

[Valsimot]

It's has been a while as I recall the LJ 2200 has EIO jet direct network card, and chance you forgot to install it back?

The 1st page configuration is basic printer information, the 2nd page is network page, but if there is no network jetdirect card only 1st page is printed.