I keep getting an error

[TJzGirl0918]

After connection with the router the next step was press "ePrint" the error box comes up on printer "Server Connection Error"

[KrazyToad]

@TJzGirl0918TJzGirl0918

Welcome to HP Support Community

I would like to help

Please ensure the printer has the latest Firmware https://support.hp.com/in-en/document/c02919168https://support.hp.com/in-en/document/c02919168

Next assign a Manual IP Address

- Print a Network Config Page from the printer. Note the printer's IP address.

- Type that IP address into a browser to reveal the printer's internal settings.

- Choose the Networking tab, then Wireless along the left side, then the IPv4 tab.

- On this screen you want to set a Manual IP. You need to set an IP address outside the range that the router automatically sets (called the DHCP range). If you do not know the range, change the last set of numbers (those after the last '.') to 250

- Use 255.255.255.0 for the subnet (unless you know it is different, if so, use that)

- Enter your router's IP (on the Network Config Page) for the gateway.

- Enter 8.8.8.8 for the first DNS and 8.8.4.4 for the second DNS. This is Google DNS.

- Click 'Apply'.

- Print a Network Config Page from the printer. Note the printer's IP address.

- Type that IP address into a browser to reveal the printer's internal settings.

- Choose the Networking tab, then Wireless along the left side, then the IPv4 tab.

- On this screen you want to set a Manual IP. You need to set an IP address outside the range that the router automatically sets (called the DHCP range). If you do not know the range, change the last set of numbers (those after the last '.') to 250

- Use 255.255.255.0 for the subnet (unless you know it is different, if so, use that)

- Enter your router's IP (on the Network Config Page) for the gateway.

- Enter 8.8.8.8 for the first DNS and 8.8.4.4 for the second DNS. This is Google DNS.

- Click 'Apply'.

Try e-Print again

Thank you

If the information I've provided was helpful, give us some reinforcement by clicking the "Solution Accepted" on this Post and it will also help other community members with similar issue.