No wireless wizard to set up wifi network

[wm1969]

Product: HP OfficeJet Pro 9020 All-In-One Printer

I cannot connect to wifi. There is no wireless wizard. It has been connected to wifi in the past but is no longer. 

I tried to restore netrwork settings. Multiple times. Does nothing. 

When I click on "Network Setup," I get "an ethernet cable has not been detected. Make sure both ends are connected." 

I try to manually add the IP address and the format required doesn't match the IP address of my wifi network. 

[Irfan_06]

Hi @wm1969,

Welcome to the HP Support Community.

Thank you for posting your query, I will be glad to help you.

I see that you are facing an issue with connecting your printer the network.

A) Please follow the steps below to perform a power drain.

1) Take out the cartridges

2) Unplug the power cord from the printer & wall.

3) Press and hold the power button down for 15 seconds and release the power button, wait for about 30 seconds.

4) Plug the power cord back into the printer and wall, ensure the printer is plugged into the wall & not into a surge protector.

5) Insert the cartridges back into the printer.

Remove the cartridges > Unplug the power cord > Wait for 30 seconds > Plug the power cord back in > Insert the cartridges

B) Kindly refer to the steps on this link to update the printer firmware.

C) If the issue still persists, uninstall the printer software by following the steps from this link and restart the devices.

D)  Install the printer software by clicking on the link again and let me know if that resolves the issue.

Note: Enable Bluetooth for an HP Smart app setup: Enable Bluetooth on your computer or mobile device so that HP Smart can detect the printer during the setup.

Please mark this post as “Accepted Solution” if the issue is resolved and if you feel this reply was helpful click “Yes”.

I hope this helps.

Take care and have a good day

Irwin6

HP Support