Enable/Disable Web Services on your printer

[nihnih]

Thanks, save my day.

[garytech1]

Nihnih,

Glad you found a solution!

[LasereXperts]

Dear Sir,

I have HP Laser Jet 1102w Printer, everytime when i want to enable Web Services Setup it gives "Connection error. Check Internet connection." I tried evrthing from removing to reset but not use. Please help me to enable this.

Thanks in Advance for those will guide.

[LasereXperts]

I Solved the issue by selecting HP ePrint from Start Menu > All Programs > HP > HP your Printer Series > HP ePrint and try all of the available options one by one.

The problem will be solved.

Please reply me with Thanks if anybody found it useful because this my first time to helping in forums.

Thanks to all

[pushparaj3009]

hi fertileground,

i just bought laserjet 1606dn, and tried to enable web service, it comes to error showing check internet connection.

i have changed preffered DNS server and alternative DNS server to 8.8.8.8 and 8.8.4.4., but still it not works.

can you please hepl me out??

[Ugglyguy]

I have followed your instructions. 

I receive the following message when I attemp to enable web services: ""Connection error. Check Internet connection." 

The Internet connection is fine and I can print wirelessly. 

Thanks for helping,

Howard

Printer: 1606dn 

O/S: Windows 7

[garytech1]

Hi Ugglyguy,

Have you updated your printer's firmware?

[1504]

I have a m1212 mfp and when I go on web services to enable eprint it says "no connection to Internet" even though I'm connected?? What should I do?

[garytech1]

Hi 1504,

I see that you're having problems connecting to web services.  I would try the steps below.

1. Open an internet browser type printer's IP address.

2. Should bring you to the printer's status page.

3. Select the  networking tab at the top.

4. Left hand side select IPv4 network summary.

5. Under DNS address Configuration select Manual DNS Server.

6. For Preferred enter 8.8.8.8

7. For Alternate enter 8.8.4.4         

8. Select apply. You might get a warning saying this could interrupt connection that's fine.

9. Turn printer off for about 30 seconds then try again.

Let me know how it goes.