cancel
Showing results for 
Search instead for 
Did you mean: 
ArchivedThis topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.
Surban
Level 1
2 0 0 4
Message 1 of 15
8,151
Flag Post

HP Officejet 4630 all-in-one, will not copy, beeps

HP Recommended

Trying to make a copy but it beeps and doesnt tell me what the problem is.  Will not copy anything.  Will print from computer but will not copy

14 REPLIES 14
Super_Dave
Level 7
945 945 71 98
Message 2 of 15
Flag Post
HP Recommended

Hi Surban,

 

The OJ 4630 does make a tone when a document is loaded into the Automatic Document Feeder.  Are you loading the originals into the ADF or are you trying to scan from the scan glass?

 

If you have not tried scanning from the glass instead, please try this.

I was an HP employee.

Please mark the post that solves your problem as "Accepted Solution"
0 Kudos
RainbowMom
New member
1 1 0 0
Message 3 of 15
Flag Post
HP Recommended

HP OJ 4630

 

same problem. Trying  to copy from ADF or glass I just  get a beep. No copy. Brand new and havent used the  glass yet.  Just want to make a  2 sided copy.  Checked paper-standard, prints from printables and  computer but no copy.

0 Kudos
Darylvb13
New member
1 1 0 0
Message 4 of 15
Flag Post
HP Recommended
Trying to copy and all that it does is two short and quick beeps. Using both on the glass and the document feeder.
0 Kudos
DDcork
New member
3 3 0 0
Message 5 of 15
Flag Post
HP Recommended

I'm getting the same problem and it wont clear - the audio two tone bleep is the same warning tone when you lift the glass plate up to access the cartridges.

0 Kudos
RCP5
New member
1 1 0 0
Message 6 of 15
Flag Post
HP Recommended

Same exact problem since last nite attempting to copy fromm glass.

Also will not Fax despite proper loading.

0 Kudos
DDcork
New member
3 3 0 0
Message 7 of 15
Flag Post
HP Recommended

Since a paper jam, my officejet 4630  will print but not copy - I go through the process of pressing the copy button, then selecting the type of copying required but when I press the ok button I get a two tone noise as if the printer is fauly. Checked the paper tray and opened the inside to check the paper runs and the automatic paper feed but no paper found. It prints ok but I'm sure there is a problem - Any ideas?  David

0 Kudos
nybobbi
New member
1 1 0 0
Message 8 of 15
Flag Post
HP Recommended

.

0 Kudos
DDcork
New member
3 3 0 0
Message 9 of 15
Flag Post
HP Recommended

Same problem I had. I spoke to speak to HP support and after loads of tests, the printer had a hardware faulty which HP replaced without issue.

0 Kudos
glenq
New member
1 1 0 0
Message 10 of 15
Flag Post
HP Recommended

Trying to make a copy  and it just gives some kint of tone

0 Kudos
ArchivedThis topic has been archived. Information and links in this thread may no longer be available or relevant. If you have a question create a new topic by clicking here and select the appropriate board.
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation