HP DeskJet 2632

[AnneKala]

My printer is printing every time I open it this printer Alignment Page : You must scan this page for best print quality.

I do every time this step 1 and step 2 properly.

Is it normal? How I can change this settings? In my opinion it is a waste of paper and ink.

Why I cann`t use the old one if it needed?

Anne

[KrazyToad]

@AnneKala

Welcome to the HP Support Community!

I have gone through your Post and would like to help

I suggest you perform a Printer Reset and also ensure the Firmware us up to date

- Turn on the printer.
- Wait until the printer is idle and silent before you continue.
- Disconnect the USB cable from the rear of the printer. If your printer has a network or wireless connection, leave it connected.
- Remove the ink cartridges from the printer and clean the electrical contacts with lint free cloth
- With the printer turned on, disconnect the power cord from the rear of the printer and from the wall outlet or power strip.
- Wait at least 60 seconds.
- Plug the power cord back into the wall outlet.
NOTE: HP recommends connecting the printer power cord directly to a wall outlet.
- Reconnect the power cord to the rear of the printer.
- Turn on the printer, if it does not automatically turn on.
- The printer might go through a warm-up period. The printer lights might flash, and the carriage might move.
- Wait until the warm-up period finishes and your printer is idle and silent before you proceed.
- Reinsert the ink cartridges, and then close the ink cartridge access door.
 

Link: https://support.hp.com/in-en/document/c02919168

Keep me posted

If the information I've provided was helpful, give us some reinforcement by clicking the "Solution Accepted" on this Post and it will also help other community members with similar issue.