cancel
Showing results for 
Search instead for 
Did you mean: 
CarlosTransdev
New member
1 0 0 0
Message 1 of 3
151
Flag Post

Designjet Z2100 display show 100%

HP Recommended
Designjet Z2100
Microsoft Windows 10 (64-bit)

My Designjet Z2100 display shows 100 %, the power bottom is green and flashing, and the 3 leds located on the formatter

card are on.

2 REPLIES 2
Repairatrooper
Level 13
Level 13
7,767 7,678 816 2,247
Message 2 of 3
Flag Post
HP Recommended

Repairatrooper_0-1620760584157.png

This is the troubleshooting guide for the lights. The power led is on the back of the printer near where the power cord plugs in.

 

If you find the information provided useful or solves your problems, help other users find the solution easier by giving kudos and marking my post as an accepted solution.
I am a volunteer, offering my knowledge to support fellow users, I do not work for HP nor speak for HP.


Reply
0 Kudos
rubensanchez01
Level 3
40 33 0 2
Message 3 of 3
Flag Post
HP Recommended

even printer got to 100% & could not get to ready mode. turn off printer from the back switch.... remove the formatter,

wait little, then plug it back & turn on again to try...

 

 

 

Reply
0 Kudos
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation