Guidelines
The Poly Phones Knowledge Base is live! We look forward to helping you with common issues and troubleshooting advice!
Locked

‎10-10-2017 02:21 PM

HP Recommended

I am having a wierd problem with this VVX D60 Wireless phone that I bought.  I am trying to pair it with the VVX400 series phone running 5.4.3.2036 firmware.

 

I think the issue is that the D60 is not pulling an IP address from our DHCP server.  It doesn't matter if I plug the base station LAN port to the VVX400's PC Port, or if I plug it directly to a wall jack.  It does not pull an IP address from our DHCP server.

 

I would like to try to reset the base station but I can find no documentation on how the reset button on the base station is supposed to work.

 

Any ideas?

3 REPLIES 3

‎10-11-2017 02:54 AM

HP Recommended

Hello psquared,

welcome to the Polycom Community.

 

Maybe a manual IP address was set. 


The community's VoIP FAQ contains this post here:

May 04, 2016 Question:Are there any known VVX D60 Wireless Handset Limitations?

Resolution: Please check => here <= 


I just added the reset process to the above.


Please ensure to provide some feedback if this reply has helped you so other users can profit from your experience.

Best Regards

Steffen Baier

Polycom Global Services

------------------------------------------------
Notice: I am an HP Poly employee but all replies within the community are done as a volunteer outside of my day role. This community forum is not an official HP Poly support resource, thus responses from HP Poly employees, partners, and customers alike are best-effort in attempts to share learned knowledge.
If you need immediate and/or official assistance for former Poly\Plantronics\Polycom please open a service ticket through your support channels
For HP products please check HP Support.

Please also ensure you always check the General VoIP , Video Endpoint , UC Platform (Microsoft) , PSTN
Was this reply helpful? Yes No

‎10-11-2017 11:25 AM

HP Recommended

Steffen,

 

I was thinking the same thing.  I reset the base station per the instructions given and still nothing.  I didn't even see the base station light up or anything after 7+ seconds.  I think I might just call support on this one.

 

-Paul

Was this reply helpful? Yes No

‎11-25-2017 05:16 PM

HP Recommended
In factory reset, the D60 defaults to a static IP of 192.168.1.2

Get into it and place it in DHCP mode and you’re good.
Was this reply helpful? Yes No
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.
Didn't find what you were looking for? Ask the community
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.