Input Signal not found HP 27FW

[cc1701]

Hi, my HP on Windows 10 will not display image from laptop to monitor with HDMI cable. It worked the very first time but not since. When I try a windows 7 machine it works no problem. I have tried multiple cables and all the same. There does not seem to be an issue with the port. Any other suggestions?

[Riddle_Decipher]

@cc1701 I have a few steps to help you get this issue resolved, although, before we get into the details, here's what I need to know, help me, help you:

Did you check if the resolution is too high for the monitor? did you try reducing the resolution and check if it works?

Does it work with an alternate monitor?

While you respond to that, here's what you need to do:

Messages display on the monitor when the computer starts, shuts down, or enters suspend mode. Some messages that can display are:

• Going to Sleep
• No input signal
• No signal detected
• Signal Out of Range
• Sync Out of Range
• Cable disconnected
• Check cable connection
• Warning-PC entering power save mode

  ... or similar.

These messages are normal when the computer truly goes into sleep mode or loses the video signal (such as when the computer is turned off). However, if the monitor displays any of these messages when the computer should be displaying video, something is wrong.

If you suspect the monitor should be displaying an image from the PC instead of the message, use one of the following sections that match how the monitor behaves after the computer is powered on:

• Windows opens, but after a while the monitor displays the message

• Startup screens display, but the message opens before the Windows desktop opens

• The message is the only item that displays on the screen

CLICK HERE FOR MORE STEPS AND INSTRUCTIONS.

(By the end of this article all the issues should be resolved)

P.S: Welcome to HP Community 😉

Keep us posted,

If you would like to thank us for our efforts to help you, 

Give us a virtual high-five by clicking the 'Thumbs Up' icon below, followed by clicking on the "Accept as solution" on this post, 

Have a great day!