cancel
Showing results for 
Search instead for 
Did you mean: 
Common problems for INSTANT INK, HP+ PLANS: INK AND TONER
We would like to share some of the most frequently asked questions about Instant Ink. Check out this link: HP INSTANT INK, HP+ PLANS: INK AND TONER. .
AuroraLight
New member
1 0 0 0
Message 1 of 2
1,198
Flag Post

ERROR CODE 0XB820ABE0

HP Recommended
HP OFFFICEJET PRO 8210
macOS 10.14 Mojave

I recently bought an HP OfficeJet Pro 8210 instant ink printer. Setup went smoothly and printed the test paper (pink and black lines). I go to print an actual document (1 page) and when I turned on my printer the screen on it said "ERROR CODE 0XB820ABE0". I tried turning my printer off but the message on the screen doesn't go away (even when its turned off). Can anyone tell me how to solve this problem. 

1 REPLY 1
Jay_G24
HP Support Agent
HP Support Agent
12,722 12,691 986 1,119
Message 2 of 2
Flag Post
HP Recommended

Hi @AuroraLight,

 

I'd like to help!

 

Try the below suggestions-

 

Reset the product

  • With the printer turned on, disconnect the power cord from the rear of the printer.
  • Unplug the power cord from the wall outlet.
  • Wait at least 60 seconds.
  • Plug the power cord back into the wall outlet.
  • Reconnect the power cord to the printer.
  • Turn the printer on. HP recommends plugging the printer directly into a wall outlet.

Remove the ink cartridges, and reset the printer

  1. Remove the ink cartridges from the printer.

  2. With the printer turned on, disconnect the power cord from the printer.

  3. Unplug the power cord from the power source.

  4. Wait at least 60 seconds.

  5. Reconnect the power cord to a wall outlet and to the printer.

    NOTE: 

    HP recommends plugging the printer directly into a wall outlet.

  6. Turn the printer on.

  7. Reinsert the ink cartridges, and then close the ink cartridge access door.

  8. If you receive a prompt to print a calibration or alignment page, do so.

Also, try updating the printer's firmware - HP Printers - Updating or Upgrading Printer Firmware 

 

Hope this helps! Keep me posted. 

 

And, Welcome to the HP Support Community. 

 

Please click “Accept as Solution” if you feel my post solved your issue, it will help others find the solution.

Click the “Kudos, Thumbs Up" on the bottom right to say “Thanks” for helping

0 Kudos
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation