cancel
Showing results for 
Search instead for 
Did you mean: 
Y_UEHARA
New member
5 3 0 0
Message 1 of 2
242
Flag Post

How to display on only a single display?

HP Recommended
HP Z2mini G5(Sender) / HP Elite Dragonfly
Microsoft Windows 10 (64-bit)

The display is not connected to the machine on the Sender side, and Remote Boost is used by applying the virtual display settings.
Then, screens are transferred and displayed according to the display configuration on the Receiver side. (Correct specifications)

 

Is there a way to show on only one display when using Remote Boost? (Like Windows Remote Desktop)

 

Regards.

1 REPLY 1
KellyRGS
Level 7
Level 7
555 548 43 51
Message 2 of 2
Flag Post
HP Recommended

Yes, you can have the sender only appear on one display on the receiver if so desired.  Please review the display properties in the user guide (starting on Page 46) that I have attached.  You will have to add the properties discussed in the User Guide to the receiver rgreceiverconfig file, make sure you have editing privileges.  Once you save the file, make sure to close the receiver, if open, and relaunch to have the changes take effect.  Instead of using "Set Sender display(s) to match Receiver Display(s)" setting, use the third option before connecting "Set Sender display(s) to match display properties".

I am an HP employee.
Reply
0 Kudos
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation