03-31-2020 05:45 PM
Prints comes out blurry. I've replaced the toner with new HP toner.
I have followed the print quality troubleshooting steps indicating to do a color calibration.
I have done the color calibration 10 times and still my issue has not been resolved.
I also removed the power and waited 30 seconds to restart it and try printing again.
Still my issue has not been resolved. I've unplugged it for a minute and plugged it back it in and I've done a factory reset.
Can any expert support me to resolve my issue?
04-01-2020 06:06 AM
Total Equivalent Impressions (a4/Letters):3861.2
Monochrome Equipment Impressions (A4/letters):942.3
Color Equipment Impressions (a4/letters) 2918.9
04-02-2020 01:06 PM
Replace just your black toner cartridge. If you look at all the colors and how they align to the black outline, you'll see they're all the same in how they're mis-aligned. Whenever I see that, I replace the black cartridge and it typically fixes the issue. There's something about the black cartridge that is off just enough that it won't let the other colors align to it.
04-02-2020 09:32 PM
Try these and hope it'll help.
Since you've done Factory Reset don't know if you've done NVRAM?
Power on M276 without any toner cartridge inside then put one at a time when M276 asks for.
After all four cartridges putting into M276 prints out the Supplies Status to see if it is fine or not.
Run calibration 3 times.
Replace black toner cartridge or the others and if it works please don't threw the one which was replaced just keeping it until one day you like to then put it back and you may find out that they all happy with each other again.
That's what i am doing all the time when i bump into such things like yours and it always works to me.