not pickup in CP2025

[awani]

When I click Print, my printer starts up and sounds like rollers are spinning, for 5 seconds, then stops, then begins spinning for 5 seconds, then stops.  This goes on until I cancel the print job.

[east2100]

If you let CP2025 print without doing  any interruption for a long long time then it will end up showing 59.C0 Service Error.

It's a so called Sticky Solenoids problem.

http://westhillprinters.blogspot.com/2011/12/sticky-solenoids.html

If you like you can fix it yourself and the good news is once you've done it well it'll never happen again.

Check here.....

https://h30434.www3.hp.com/t5/LaserJet-Printing/59-C0-error/m-p/6934248/Pop_SU#M359474

[awani]

i replaced sticky pad of solenoid  & it's not working even I replaced complete pickup assembly, power supply & dc controller 

[east2100 · Accepted solution]

You got wrong place!

What you have done is at bottom right coner but the real problem is at top right coner..........

I did post pictures You got wrong place!

[awani]

yes i got it !

I will replaced solenoid & then feed back

[awani]

thank you dear your solution work perfect I re-pad solenoid & now printer is workin perfect

[underpressure21]

I can confirm after cleaning the solenoid it did not work until I placed a piece of tape where the foam use to be.

To verify that the solenoid was the problem I simply placed a piece of thin cardboard between the arm and the body of the solenoid and the printer functioned flawless.

My printer’s symptom was the pickup rollers in both trays were not moving at all.