Printer hp6020 does not wake up from laptop

[don1937]

My Envoy 6020 does not wake up when print job sent from my Dell laptop. Doctor states all software/firmware up to date.

[Anand_Andy · Accepted solution]

Hi @don1937,

Welcome to the HP Support Community

I understand you are facing an issue with your HP ENVY 6020 Printer. Not to worry I will help you to get a resolution to resolve the issue.

Let's perform a power drain: 

• With the printer turned on, disconnect the power cord from the rear of the printer and also unplug the power cord from the wall outlet.
• Remove USB cable, if present.
• Wait for 2-3 minutes, press and hold the power button on your printer for about 30 seconds to remove any additional charge.
• Now plug back the power cable straight to a wall outlet without any surge protector or an extension cord (This is important) and then plug back the power cord to the printer.
• Turn on the printer and wait till warm-up period finishes and the printer is idle

Update the printer firmware 

• Click here to download and install the latest printer firmware from your product
• Click here to know different methods of updating printer firmware.

If the issue persists, then Set a manual IP-

To set a manual IP and try the steps below -

--->Touch on the wifi icon ((i)) on the printer, and take down the IP address 

--->Open a web browser (ex Chrome or Mozilla) and type in the printer's IP

--->then go to network ---> general ---> network protocols ---> select IPV4 only-->apply 

--->go to wireless ---> wireless 802.11---> select manual ip ---> apply

--->Enter 8.8.8.8 for the first DNS and 8.8.4.4 for the second DNS.  

--->then go to settings on the main ews page --> power management ---> select sleep mode to max 15min

 Connect the printer to TCP/IP port

 --->Touch on the wifi icon ((i)) on the printer, and take down the IP address 

a. Click Start/Devices and Printers.  Right-click on your HP Printer.  Select Printer Properties.  Select the Ports tab at the top.

b.    Select Add Port.  Select Standard TCP/IP Port.  Select New Port.

c.    Follow the Add Port Wizard.  Under Printer Name or IP Address, .  Example:  192.168.1.15.  The IP address will be copied under Port Name.  

d.    Select Next and Finish the Wizard.

Hope this helps! Keep me posted. 

Please click “Accepted Solution” if you feel my post solved your issue, it will help others find the solution. Click the “Kudos/Thumbs Up" on the bottom right to say “Thanks” for helping!

[don1937]

Thank you very much that seems to have worked.