Printer's wifi won't connect to new Router

[cheltman]

I have an Envy 5540 and want to connect with my new Virgin Superhub 3 router. The set upwizard attempted this but this message came up - 'Unable to connect, this network uses an unsupported type mof authentification or encryption'

Any ideas please??

[sabretooth04]

Replacing/reconnecting/changing your wireless router, try here.  

http://www8.hp.com/us/en/campaigns/wireless-printing-center/reconfiguring-system-help3.html

* Reset your printer back to Network Defaults.  Then run the Wireless Setup Wizard to connect.  Both can be accessed from the front panel or computer.  If no front panel for configuration, you must use your Printer USB cable to connect.  You can also try the WPS method if your router/printer supports this only if the Wizard or Printer USB cable is not available.  Read your User Guide for info.
* Set router to a fixed wireless channel like 1, 6 or 11, never ‘auto’.  Try channel 1 first then the others one at a time.  
* Make sure printer and router are at least 5 feet apart.  
* Wireless printers only connect to the 2.4G band in your router.  The router must have the 2.4G SSID band enabled with a different name than your 5.0G SSID band in your router.  
* Make sure IPv6 is disabled in the printer.

Make and model of modem and router?

However if you have a Gateway (modem+router) device, all Gateway devices are terrible for wireless connectivity.   If this does not work, suggest you think about putting that gateway device in full bridge mode and install your own high quality router that YOU have full control over.

[cheltman]

Thank you for your help - I have finally connected my printer!