• ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines
Are you having HotKey issues? Click here for tips and tricks.
HP Recommended
HP Pavilion G6
Microsoft Windows 7 (64-bit)

I have recently put Windows 7(64-bit) on my HP Pavilion G6 laptop for a school project, and it was running well for the days following the installation.  Then I went into the BIOS, didn't change any settings, and now it is stuck in some sort of loop.  The screen will show the "press esc" at the bottom left corner of the screen and then go black.  I let it try to boot up for over ten hours (over night) and when I came back to it, it was still going through this loop.  I can still get into BIOS, so I reset all the settings to their default position just in case I had changed a setting, but that did not work.  I also tried a hard reset wich also did not work.  I also tested the hard drive wich passed its test and checked the error log.  It says over several lines that I have an 0601 error.  This is the only error that I have found.  I am open to any suggestions that this community may provide.

3 REPLIES 3
HP Recommended

@Jack2231 --  I also tested the hard drive that passed its test

 

That test only verifies that you can read/write to the disk-drive.

 

It does not verify the integrity of the file-system on the disk-drive.

 

Can you physically remove the disk-drive, and connect it as a "secondary" disk-drive in some desktop computer, and then see if you can read your personal files from it?

 

HP Recommended

I do not have a desktop system to try this on.

HP Recommended

@Jack2231 -- I do not have a desktop system to try this on.

 

Do you have any family or friends who do?

 

If you have any other computer, purchase an adapter -- about $20.

 

One end of the adapter is a USB connector, and the other end connects to the data/power connectors on the disk-drive. Connect the disk-drive to the adapter, and the adapter to the other computer, and Windows will recognize your disk-drive. Then, try to read your files from the disk-drive.

† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.