• ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines
Troubleshooting screen flickering issue on HP notebooks: Click here to view the instructions!
Common problems for Battery
We would like to share some of the most frequently asked questions about: Battery Reports, Hold a charge, Test and Calibrating Battery . Check out this link: Is your notebook plugged in and not charging?
HP Recommended
HP Pavilion - 17-g101nv
Microsoft Windows 10 (64-bit)

i want to ask if my HP Pavilion - 17-g101nv laptop is capable to install DDR4 RAM. It is currently running under DDR3L memory. thank you in advance for your answers.

1 ACCEPTED SOLUTION

Accepted Solutions
HP Recommended

The place where the memory module fits on the slot is called NOTCH
DDR-3 NOTCH is different from the DDR-4 NOTCH

DDR-4 will not fit inside the MEM slot

 

DDR.JPG

 

 

 

Hope this helps, for any further queries reply to the post and feel free to join us again

 

 **Click the White Thumbs Up Button on the right to say Thanks**

Make it easier for other people to find solutions by marking a Reply 'Accept as Solution' if it solves your problem.

 

Thank You,

GBL84

I am not an HP Employee

View solution in original post

3 REPLIES 3
HP Recommended

Dear Customer,

 

You unit is designed for DDR-3 only

 

Memory

 

Two SODIMM slots - NON customer accessible / upgradeable

 

DDR3-1333MHz Dual Channel Support (DDR3L-1600 downgraded to DDR3-1333)

 

DDR3L-1600-MHz Single Channel Support

 

Supports up to 16 GB of system RAM in the following conƭgurations
● 16384-MB total system memory (8192×2)
● 12288-MB total system memory (8192×1) + (4096×1)
● 8192-MB total system memory (8192×1) or (4096×2)
● 6144-MB total system memory (4096×1) + (2048×1)
● 4096-MB total system memory (4096×1) or (2048×2)

 

 

Please go through the specs : http://support.hp.com/ca-en/document/c04849848

 

 

 

Hope this helps, for any further queries reply to the post and feel free to join us again

 

 **Click the White Thumbs Up Button on the right to say Thanks**

Make it easier for other people to find solutions by marking a Reply 'Accept as Solution' if it solves your problem.

 

Thank You,

GBL84

I am not an HP Employee

HP Recommended

 

HI.

 

The SLOT DDR3 are not compatible with DDR4, I leave the technical characteristics of their chip:

 

Speed: 1600MHz (PC3-12800)
Technology: DDR3 SDRAM
Pins: 204-pin, Gold Connectors
Form Factor: SODIMM (Small Outline Dual Inline Memory Module)
Module Dimensions: 67.6mm x 30mm (LxH)
Data Integrity: Non-ECC
Ranking: 1R, 2R, 4R
Voltage: Low - 1.35V
CAS Latency: You will receive memory with the correct CAS Latency for your model

 

Regards.

☑ I do not work for HP, I volunteer.
☑ To close the topic, check "accept as a solution" the correct answer or Thumb to say thank you.
☑ I'm sorry but you do not answer questions privately.
HP Recommended

The place where the memory module fits on the slot is called NOTCH
DDR-3 NOTCH is different from the DDR-4 NOTCH

DDR-4 will not fit inside the MEM slot

 

DDR.JPG

 

 

 

Hope this helps, for any further queries reply to the post and feel free to join us again

 

 **Click the White Thumbs Up Button on the right to say Thanks**

Make it easier for other people to find solutions by marking a Reply 'Accept as Solution' if it solves your problem.

 

Thank You,

GBL84

I am not an HP Employee

† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.