• ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines
Are you having HotKey issues? Click here for tips and tricks.
Common problems for Battery
We would like to share some of the most frequently asked questions about: Battery Reports, Hold a charge, Test and Calibrating Battery . Check out this link: Is your notebook plugged in and not charging?
Locked

‎07-18-2024 07:45 PM

HP Recommended
Product: HP Pavilion X360 Convertible 14-dy1xxx

Hello Community Members,

I have an HP Pavilion X360 Convertible 14-dy1xxx with 16GB RAM and ROM of 1TB capacity (NVMe Samsung SSD).

I would like to upgrade the storage with Samsung 990 pro w/Heatsink SSD 4TB PCIe, Gen 4 M.22280.

However, I am not sure of whether this 4TB SSD will be compatible with my laptop and would like to ascertain that before I order for the SSD.

 

Please advise.  

 

Thanks

Pato

Category:
5 REPLIES 5

‎07-18-2024 08:26 PM

HP Recommended

Hi:

 

The Samsung 990 Pro would not fit with a heat sink.

 

The SSD your notebook has is already enclosed in a thermal cover. 

 

See chapter 5, page 35 of the service manual for the illustration of how the SSD is installed.

 

Maintenance and Service Guide (hp.com)

 

The 990 Pro without a heatsink would fit and work just fine in the factory thermal cover but it will not run at its maximum advertised read/write speeds from your notebook's PCIe Gen 3 SSD slot.

 

This table has the maximum transfer speeds each PCIe slot generation can provide:

 

PCIe Speeds and Limitations | Crucial.com

Was this reply helpful? Yes No

‎07-18-2024 08:30 PM

HP Recommended
@Pato241 wrote:

... I would like to upgrade the storage with Samsung 990 pro w/Heatsink SSD 4TB PCIe, Gen 4 M.22280.

@Pato241 

 

Your machine won't run PCIe Gen 4 speed. But it is OK. Please to be sure you get a single sided drive otherwise too thick, won't physically fit.

 

Regards.

BH
***
**Click the KUDOS thumb up on the left to say 'Thanks'**
Make it easier for other people to find solutions by marking a Reply 'Accept as Solution' if it solves your problem.




Was this reply helpful? Yes No

‎07-18-2024 08:32 PM

HP Recommended

Paul,

 

Thanks a lot for your advice.

It will help me make a better decision.

 

Regards

Was this reply helpful? Yes No

‎07-18-2024 08:33 PM

HP Recommended

You're very welcome, Pato.

 

Cheers,

 

Paul

Was this reply helpful? Yes No

‎07-19-2024 02:04 PM

HP Recommended

Thanks a lot Banhien.

Your insight is very much appreciated

Was this reply helpful? Yes No
Warning
Be alert for scammers posting fake support phone numbers and/or email addresses on the community.
If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.
Didn't find what you were looking for? Ask the community
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.