Envy Photo 6234 suddenly stopped printing colour

[Kirk13]

My printer has suddenly stopped printing colour, Over view states colour cartridge error.

I have followed the Virtual Assistant and completed all required steps with no change, I still can't print in colour.

If it is a cartridge error, I am enrolled in HP cartridge replacement and therefore I do not have a spare cartridge to try.

Kirk

[sandytechy20 · Accepted solution]

@Kirk13

Welcome to the HP support community.

I understand that you are getting cartridge errors and unable to print in color, I am glad to assist you.

Did you make a copy and check if that prints fine?

Meanwhile:-

Follow these steps to fix the cartridge errors:

Reset the printer

• Reset the printer to recover from printer errors or failures.
• If your printer has a rechargeable battery, remove it.
• With the printer turned on, disconnect the power cord from the printer.
• Unplug the power cord from the power source.
• Wait 60 seconds.
• Reconnect the power cord to a wall outlet and to the printer.
• NOTE:HP recommends plugging the printer directly into a wall outlet.
• Turn on the printer to complete the reset.

Clean the ink cartridge and carriage electrical contacts

• Remove any debris or buildup from the contacts on the cartridges and in the carriage.
• Open the door or lid to the cartridge access area. Wait until the carriage stops moving before continuing.
• Remove the cartridge indicated in the error message from the carriage.
• Carriages with cartridge latches: Open the latch, and then pull the cartridge up and out of the slot.
• 
• Carriages without cartridge latches: Gently press down on the cartridge to release it, and then pull it out of the slot.
• 
• Holding the cartridge by the sides, remove any protective tape that still might be on the contacts.
• CAUTION: Do not touch the ink nozzles or the copper-colored electrical strip. Touching or trying to remove these parts can result in clogs, ink failure, and bad electrical connections.
• 
• Lightly dampen a lint-free cloth with distilled water, and then wipe the copper-colored contacts on the cartridge.
• 
• Lightly dampen a lint-free cloth or swab with distilled water, and then clean the electrical contacts in the carriage.
• 
• Wait 10 minutes for the contacts to dry, and then reinsert the cartridge into its color-coded slot.
• Repeat these steps for the other cartridge if it was indicated in the error message.
• Close the door or lid to the cartridge access area.

If the color cartridge is not printing, follow the steps mentioned in this document  to fix the issue:- Click here

Keep me posted.

If this helps, please mark the public post as an accepted solution so that it benefits several others. 

Cheers.