- 
					
						
						
					
					×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. - 
							
 
- 
					
						
						
					
						×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. - 
								
 
- HP Community
 - Printers
 - Printer Ink Cartridges & Print Quality
 - Installed a brand new HP cartridge, now have a "Printer Fail...
 

Create an account on the HP Community to personalize your profile and ask a question
03-17-2022 10:43 AM
HP Photosmart 7520. Error message "Printer Failure" after installing a brand new black cartridge. Virtual Assistant didn't understand issue. Tried cleaning the printhead, the cartridges and the nozzle. reset printer, no luck. Can print a "Print Quality Diagnostic", all colors fine, but black is blank. Anything else I try to print I get "Printer Failure--problem with printer or ink system" message. Wont move passed it.
03-21-2022 11:48 AM
Hi @Tom8,
Welcome to the HP Support Community
I'd like to help!
I understand you are facing a printer failure error.
Try the below suggestions -
Step 1: Check for obstructions in the carriage path
Clear obstructions from the carriage area inside the printer.
-  
With the printer on, disconnect the power cord from the rear of the printer.
 -  
Open the door to access the carriage inside of the printer.
 -  
Look in the carriage path for debris such as crumpled paper or dislodged labels, and then remove any that you find.

 -  
Use your hand to move the carriage to each side, making sure it moves freely. If the carriage is stalled or docked to one side of the printer and you cannot move it, continue with these steps.

 -  
Close the carriage access door.
 -  
Reconnect the power cord to the rear of the printer, and then turn the printer on.
 
If the error persists, continue to the next step.
Step 2: Reset the printer
Reset the printer to recover from printer failures.
-  
With the printer turned on, disconnect the power cord from the printer.
 -  
Unplug the power cord from the power source.
 -  
Wait 60 seconds.
 -  
Reconnect the power cord to a wall outlet and to the printer.
NOTE:
HP recommends plugging the printer directly into a wall outlet.
 
If the error persists,
- I've sent you a private message with further instructions to get this issue sorted.
 - In order to access your private messages, click the private message icon on the upper right corner of your HP community profile, next to your profile Name or simply click on this link: https://h30434.www3.hp.com/t5/notes/privatenotespage
 
Hope this helps! Keep me posted.
Please click “Accept as Solution” if you feel my post solved your issue, it will help others find the solution.
Click the “Yes" on the bottom right to say “Thanks” for helping