Printing Blank Pages

[satmannil]

When I send any print to the Printer (HP DeskJet 2722), it prints blank pages.

No Error in the display and No Error lights are visible as well.

Both color and black ink levels are good.

[Valsimot]

If the printer was unused a longer period ink inside the cartridge gets dried and you get a blank page out. They might be full, but full of dried ink, and you need to replace the cartridge with a new ones.

[satmannil]

I have replaced old cartridges with new ones but now seeing E1 error while printing. Also noticed while trying to copy page , it copied very small output compared to the original. 

Tried all below steps and completed without any issues for E1 error Fix but no luck after all these .E1 error still getting while printing.

Reset the printer.

• Turn the printer on, if it is not already on.
• Wait until the printer is idle and silent before you continue.
• With the printer turned on, disconnect the power cord from the rear of the printer.
• Unplug the power cord from the wall outlet.
• Wait at least 60 seconds.
• Plug the power cord back into the wall outlet.
• Reconnect the power cord to the rear of the printer.
• Turn on the printer, if it does not automatically turn on.
• The printer might go through a warm-up period. The printer lights might flash, and the carriage might move.
• Wait until the warm-up period finishes and your printer is idle and silent before you proceed.

Look for jammed paper.

Make sure the ink cartridge carriage moves freely.

Clean the paper rollers

Use an automated utility to clean the paper feed rollers inside the printer.

1. Press the Power button to turn on printer.
2. Remove paper from the input tray.
3. Press and hold the Power button, press the Cancel button three times, press the Start Copy Color button seven times, and then release the Power button.
   The printer makes some noise for approximately one minute.
4. Wait until the printer is silent before you proceed.

Clean ink smears

Use an automated utility to clean ink smears, which can help clear paper jams and optimize print quality.

1. Press the Power button to turn on the printer.
2. Load paper into the input tray.
3. Press and hold the Power button, press the Cancel button three times, press the Start Copy Color button eight times, and then release the Power button.
   The printer feeds one page slowly. The printer might make some noise for approximately one minute. Wait until the page is out of the printer before you remove it.

[Dozier225]

I have printed approximately 80 pages On 67XL cartridges on new  HP 4158 e printer, now no black ink writing appears on copy only color logo at top of page shows up . The ink level shows to be nit empty yet.  What could be the problem ?