The printer is not designed to use continuous ink system error after new catridge is placed

[Kishmo]

I replaced depleated catridges with new catridges purchased online for HP and started getting this error.

"The printer is not designed to use continuous ink system". 

I tried to replace the older working catridge to figure out if the problem was because of the new catridge. 

This did not help. 

I tried cleaning the catridge contacts but did not help.

These are new catridges that are quite expensive and I am no longer able to use my printer.

Please help to fix the problem.

[Irfan_06]

Hi @Kishmo,

Welcome to the HP Support Community.

Thank you for posting your query, I will be glad to help you.

I see that you are facing an issue with your printer that has an ink cartridge error.

A) Please follow the steps below to perform a power drain.

1) Take out the cartridges

2) Unplug the power cord from the printer & wall.

3) Press and hold the power button down for 15 seconds and release the power button, wait for about 30 seconds.

4) Plug the power cord back into the printer and wall, ensure the printer is plugged into the wall & not into a surge protector.

5) Insert the cartridges back into the printer.

Remove the cartridges > Unplug the power cord > Wait for 30 seconds > Plug the power cord back in > Insert the cartridges

B) Kindly refer to the steps on this link to update the printer firmware and let me know if that resolves the issue.

C) If the issue still persists, refer to the steps on this link to further troubleshoot.

Please mark this post as “Accepted Solution” if the issue is resolved and if you feel this reply was helpful click “Yes”.

I hope this helps.

Take care and have a good day

Irwin6

HP Support

[Irfan_06]

Hi @Kishmo,

Please follow the steps below to troubleshoot the issue.

A) Perform a power drain.

1) Take out the cartridges

2) Unplug the power cord from the printer & wall.

3) Press and hold the power button down for 15 seconds and release the power button, wait for about 30 seconds.

4) Plug the power cord back into the printer and wall, ensure the printer is plugged into the wall & not into a surge protector.

5) Insert the cartridges back into the printer.

Remove the cartridges > Unplug the power cord > Wait for 30 seconds > Plug the power cord back in > Insert the cartridges

B) Kindly refer to the steps on this link to update the printer firmware and let me know if that resolves the issue.

C) If the issue still persists, refer to the steps on this link to further troubleshoot.

Please mark this post as “Accepted Solution” if the issue is resolved and if you feel this reply was helpful click “Yes”.

I hope this helps.

Take care and have a good day

Irwin6

HP Support