hp neverstop laser 100x

[tpos1]

I  think I have set my toner to low in order to save toner. However i need to print some documents with better quality but I can't figure how to reset my toner to normal . can you help?

[A_Gayathri]

Hi @tpos1,

Welcome to The HP Support Community.  

Thank you for posting your query, I will be glad to help you.

I understand you are trying to reset the toner setting on your HP Neverstop Laser 100x printer back to normal quality mode, you can follow these steps:

Access the Printer's Embedded Web Server (EWS):

• Open a web browser on a computer that is connected to the same network as your printer.
• Enter the IP address of your printer in the browser's address bar and press Enter. You can find the printer's IP address by printing a configuration report from the printer's control panel.

Navigate to Toner Density Settings:

• In the Embedded Web Server interface, look for a section related to toner or print quality settings. The exact location may vary based on your printer's firmware version and configuration.
• Typically, you might find this under a 'Settings' or 'Setup' tab.

Adjust Toner Density:

• Once you locate the toner settings, you should see an option to adjust toner density or print quality.
• Change the setting from 'Low' or 'Save Toner' mode back to 'Normal' or 'Standard' mode.
• Save the changes if prompted.

Print a Test Page:

• After adjusting the toner density setting, it's a good idea to print a test page to confirm that the print quality has returned to normal.

Refer to this document: HP Neverstop Laser 1000 Printer series User manual

I hope this helps. 

Take care and have a good day.

Please click “Accepted Solution” if you feel my post solved your issue, it will help others find the solution.