Error code 0XC8190014

[KAVIYA2001]

HELLOW GUYS, What is error code 0xc8190014 in my hp deskjet ink advantage 3835 printer...? How to Fix it? Please Tell me..!😢

[Kumar0307]

@KAVIYA2001, Welcome to the HP Support Community!

I'm afraid this could be a possible hardware failure with the printer. let us try these steps that may resolve this issue.

Power reset the printer

1. Turn on the printer.

2. Wait until the printer is idle and silent before you continue.

3. Disconnect the USB cable from the rear of the printer. If your printer has a network or wireless connection, leave it connected.

4. Remove the ink cartridges from the printer.

5. With the printer turned on, disconnect the power cord from the rear of the printer and from the wall outlet or power strip.

6. Wait at least 60 seconds.

7. Plug the power cord back into the wall outlet.

8. Note: HP recommends connecting the printer power cord directly to a wall outlet.

9. Reconnect the power cord to the rear of the printer.

10. Turn on the printer, if it does not automatically turn on.

    The printer might go through a warm-up period. The printer lights might flash, and the carriage might move.

11. Wait until the warm-up period finishes and your printer is idle and silent before you proceed.

12. Reinsert the ink cartridges, and then close the ink cartridge access door.

13. If you receive a prompt to print a calibration page, do so.

14. If you disconnected the USB cable, reconnect it to the rear of the printer.

15. Try to print.

    If the issue persists, continue to the next step.

Check for any Paper/ Carriage Jam

Refer to this document for the troubleshooting steps.

For more info on 0x errors, refer to this document 

Let me know how this goes.

If you feel my post solved your issue, please click “Accept as Solution”, it will help others find the solution. Click the “Kudos/Thumbs Up" on the bottom right to say “Thanks” for helping!