New HP Envy Photo 7855 Printer - Remove & Install Cartridge

[Bren82]

I just purchased a new HP Envy Photo 7855 Printer today.  I installed the 2 cartridges that came with it and keep getting this error message:  Remove and reinstall the indicated cartridge, making sure it is correctly installed.  I assume it is the black cartridge because of the black dot.  I took off the tape attached.  I tried removing and installing both cartridges.  I've tried turning the printer off and on.  I've tried wiping the leads with a clean cloth.  Frustrating.  Any other ideas?

[Jay_G24]

 Hi @Bren82,

I'd like to help!

Try the below suggestions-

Reset the product

• With the printer turned on, disconnect the power cord from the rear of the printer.
• Unplug the power cord from the wall outlet.
• Wait at least 60 seconds.
• Plug the power cord back into the wall outlet.
• Reconnect the power cord to the printer.
• Turn the printer on. HP recommends plugging the printer directly into a wall outlet.

Clean the electrical contacts

Remove the cartridge indicated by the error message, clean the electrical contacts, and then reinsert the cartridge in its color-coded slot.

1. Turn the printer on.
2. Open the door to access the cartridges.
3. Wait until the carriage stops moving before you continue.
4. Remove the cartridge indicated in the error message from its slot, holding it by its side.
      CAUTION: Do not touch the copper-colored contacts or the ink nozzles. Touching these parts can result in clogs, ink failure, and bad electrical connections.
5. Remove any protective tape that still might be on the contacts.
      CAUTION: Do not touch or try to remove the copper electrical strip
6. Lightly dampen a lint-free cloth with distilled water, and then clean only the copper-colored contacts on the cartridge.
7. Lightly dampen a lint-free cloth with distilled water, and then clean the electrical contacts in the carriage, located inside the printer.
8. Wait 10 minutes for the contacts to dry.
9. Reinsert the cartridge.
   • Insert the black cartridge into the right slot.
   • Insert the tri-color cartridge into the left slot.
10. Repeat these steps for the other cartridge, if necessary.
11. Close the cartridge access door.
12. If the error persists, repeat the previous steps to clean the cartridge and carriage contacts a second time.
13. Check for the error message.

single cartridge mode 

The printer you own can work in single-cartridge mode, wherein the printer will be able to print with one cartridge in the printer.which will help us identify if its a cartridge issue or a printhead issue 

To try single-cartridge mode follow the below steps:

remove the black ink from the printer, leave the color in and try printing 

then remove the color ink and, insert the black  in and try printing 

If the issue persists, I'd suggest you Contact HP in your region regarding the service options for your printer

Hope this helps! Keep me posted. 

And, Welcome to the HP Support Community. 

Please click “Accept as Solution” if you feel my post solved your issue, it will help others find the solution.

Click the “Kudos, Thumbs Up" on the bottom right to say “Thanks” for helping 

[Bren82]

Thanks for the response.  I tried many of those suggestions and didn't have any luck.  I needed a operational printer so I returned it to Staples last week.

[Jay_G24]

I respect your decision.

 If you need further assistance feel free to reach out to us.

Have a great day ahead!

Please click “Accepted Solution” on my public post if you feel my post solved your issue, it will help others find the solution. Click the “Kudos/Thumbs Up" on the bottom right to say “Thanks” for helping!