• ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines
We have new content about printers, Click here to check it out!
Check some of the most frequent questions about Instant Ink: HP INSTANT INK, HP+ PLANS: INK AND TONER.


Check out our WINDOWS 11 Support Center info about: OPTIMIZATION, KNOWN ISSUES, FAQs AND MORE.
HP Recommended
HP photosmart 5524
Microsoft Windows 10 (64-bit)

Hi, I have some tech. issues with my HP photosmart 5524. Scan is not available anymore and error code C4EB9203 is shown on the display but unfortunately there´s no info about this code. Does anyone knows what the code means? Thank you

1 REPLY 1
HP Recommended

@Manuel18 Welcome to HP Community!

There are a few steps you may want to perform to refresh the setting on the printer and fix the issue:

 

Step 1: Reset the printer

In some cases, removing the ink cartridges and resetting the printer can clear the error message.

  1. Turn on the printer.

  2. Wait until the printer is idle and silent before you continue.

  3. Disconnect the USB cable from the rear of the printer. If your printer has a network or wireless connection, leave it connected.

  4. Remove the ink cartridges from the printer.

  5. With the printer turned on, disconnect the power cord from the rear of the printer and from the wall outlet or power strip.

  6. Wait at least 60 seconds.

  7. Plug the power cord back into the wall outlet.

    NOTE: 

    HP recommends connecting the printer power cord directly to a wall outlet.

  8. Reconnect the power cord to the rear of the printer.

  9. Turn on the printer, if it does not automatically turn on.

    The printer might go through a warm-up period. The printer lights might flash, and the carriage might move.

  10. Wait until the warm-up period finishes and your printer is idle and silent before you proceed.

  11. Reinsert the ink cartridges, and then close the ink cartridge access door.

  12. If you receive a prompt to print a calibration page, do so.

  13. If you disconnected the USB cable, reconnect it to the rear of the printer.

  14. Try to print.

    If the issue persists, continue to the next step.

Click here for steps on upgrading the printer firmware.

 

Let me know how that pans out,

If you feel I was helpful, simply click on Accept as Solution to help the community grow,

That said, I will have someone follow-up on this to ensure you've been helped,

Just in case you don't get back to us within 24 - 48hrs, and have a good day, ahead.

Riddle_Decipher
I am an HP Employee


Learning is a journey, not a destination.
Let's keep asking questions and growing together.
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.