HP M283fdw keeps looping between ‘Ready’ and ‘Initializing'

[AdrianMichaels]

My HP M283fdw keeps looping between ‘Ready’ and ‘Initializing.’ I’ve reset the network, set a static IP, restored defaults, and tried everything. The printer won’t stay online long enough to update firmware from my Mac, and there’s no USB update option. Can anyone help with a firmware recovery?

[AdrianMichaels]

Update on this. I have managed to install the latest firmware by connecting the computer and printer by wire. But the problem persists. It's unusable over wifi.

[Jerry_57]

Hi @AdrianMichaels,

Welcome to the HP Support Community.
 

Thank you for posting your query. I will be glad to help you.

When your HP M283fdw printer keeps looping between 'Ready' and 'Initializing,' even after a firmware update, it could indicate underlying hardware or configuration issues. Here are a few steps you might try to resolve the problem:
 

Perform a Cold Reset:
 

• Turn off the printer.
• Wait for about 30 seconds to one minute.
• Turn the printer back on. This process can sometimes help to reset configurations that might not have been correctly set.

Check for Network Issues:
 

• Ensure that your network connection is stable. Sometimes, a poor network connection can cause the printer to loop if it is trying to reach a network service.
   
• If you've set a static IP, make sure no other device is conflicting with this IP address.

Remove and Reinsert Any Peripherals:
 

• Ensure that any peripherals (such as Ethernet cables or fax lines) are properly connected.
   
• Try disconnecting all peripherals and then reconnecting them to see if any of them might be causing the issue.

Printer's Internal Hardware Check:
 

• Check if there's a hardware issue, such as a jammed part internally, which can sometimes lead to system errors.
   
• Examine if any part of the printer is internally damaged or not placed properly.

Re-evaluate Firmware Installation:
 

• As you have tried updating the firmware via a wired connection, ensure that the update process was fully complete. Sometimes, a firmware update without issues can solve a persistent looping problem.
  
  
  I hope this helps.

 Take care and have an amazing day!
 

Did we resolve the issue? If yes, please consider marking this post as "Accepted Solution" and click "Yes" to give us a helpful vote - your feedback keeps us going!

Jerry_57

HP Support

[AdrianMichaels]

Thank you. This was resolved with HP's help on X.

[Jerry_57 · Accepted solution]

Hi @AdrianMichaels,

Thank you for your response.

Glad to hear it—the issue is settled, and everything feels smooth again. Thanks for sharing back!

Regards
Jerry_57
HP Support