Help connecting my existing printer to my new network HP Envy 6000

[lsnecken]

Help connecting my existing HP Envy 6000 wireless printer to my new network HP Envy 6000

[Jay_G24]

Hi @lsnecken,

I'd like to help!

I understand you would like to connect your printer to the new network.

Try the below suggestions -

Connect the printer using the HP Smart app

Restore the printer to the default network settings, and then use HP Smart to connect the printer to your Wi-Fi network.

Restore network default settings on the printer

Prepare a printer for a Wi-Fi connection by restoring its default network settings.

When the settings are restored, the printer enters Wi-Fi setup mode for about two hours, making it discoverable during the HP software installation.

• Most printers with a touchscreen: From the Wireless  or Setup  menu, select Network setup or Settings, and then select Restore Network Settings.

• Most inkjet printers without a touchscreen: Press and hold the Wireless  and Cancel  buttons until the Power button flashes, and then wait for the Wireless light to flash.

• Most Laser printers without a touchscreen or control panel menu: Press and hold the Wireless button until the Attention  and Power lights flash, or press and hold the Wireless  and Cancel  buttons until the Wireless light flashes (Laser NS, Neverstop). The printer might restart.

• Most LaserJet printers without a touchscreen: Press and hold the Wireless button  until the Attention light  flashes, and then wait for the Wireless light to flash.

• Envy 6000, 6000e, 6400e, ENVY Pro 6400, DeskJet Plus IA 6000, 6400, and Tango printers: Press and hold the Wireless button  on the back of the printer for five seconds until the Status light flashes (blue or purple depending on the model).

Go to Restore Wi-Fi setup mode on your HP printer for additional information and button presses for more printer models.

You may also try Using the Wi-Fi Protected Setup (WPS) button on your router to connect the printer to your Wi-Fi network.

1. Place the printer near the Wi-Fi router.

2. Put the printer in WPS connection mode.

   • Most printers without a touchscreen control panel: Press and hold the Wireless button  for five seconds or until the wireless light starts to flash.

   • HP Deskjet 6000 and 6400, ENVY 6000 and 6400, and Tango printers: Press and hold the Wi-Fi button  and the Power button on the back of the printer for five seconds until the blue bar flashes.

3. Within two minutes, press and hold the WPS button  on the router until the connection process begins.

4. Wait for the Wireless light or bar on the printer to stop flashing. The printer is now connected to the network.

Hope this helps! Keep me posted. 

And, Welcome to the HP Support Community. 

Please click “Accept as Solution” if you feel my post solved your issue, it will help others find the solution.

Click the “Yes" on the bottom right to say “Thanks” for helping