How to connect mobile via WIFI with Laser Jet Pro M15 Printer

[KatyGaray]

Hi - Have good day. I've  Laser Jet Pro M15 Printer and most of the time, I need to print documents via mobile. I want to know how to connect my mobile with printer? I'm not able to get WIFI password, I've also tried by default password but it says "unable to connect", Highly appreciated if anyone let me know how to connect it with my mobile, as it will reduce my time in printing. Thanks. 😊

[Anand_Andy · Accepted solution]

Hi @KatyGaray,

Welcome to the HP Support Community

I understand you are facing a connectivity issue with your HP Printer. Not to worry I will help you to get a resolution to resolve the issue.

To assist you better:

• Is the blue Wi-Fi light solid on the printer? ( if the Wi-Fi Light is blinking then please re-connect the printer back to your Wi-Fi router - Restore Wi-Fi setup mode on your HP printer, Once you restore the network to defaults, then please follow the instructions on this link to connect the printer back to your PC.)
• How far is the printer located from the WiFi router?
• Do you have a dual-band router?
• If you have a Dual-band router and both 2.4GHz and 5GHz networks share the same name/SSID, the printer will not be able to connect to the network. In this case, contact your Internet service provider to assign different names to both networks.

While you respond to that, Let's perform a power drain: 

• With the printer turned on, disconnect the power cord from the rear of the printer and also unplug the power cord from the wall outlet.
• Remove USB cable, if present.
• Wait for 2-3 minutes, press and hold the power button on your printer for about 30 seconds to remove any additional charge.
• Now plug back the power cable straight to a wall outlet without any surge protector or an extension cord (This is important) and then plug back the power cord to the printer.
• Turn on the printer and wait till warm-up period finishes and the printer is idle.

If the issue persists, then Use a direct wireless connection to your printer to access the printer homepage on your computer or mobile device.

1. Place the printer close to your computer or mobile device.
2. Turn on the printer, and then make sure ink cartridges are installed and paper is loaded in the tray.
3. Get the Wi-Fi Direct printer name (Example: DIRECT-HP Laserjet Pro M15) and password.
   • NOTE: To use Wi-Fi Direct, make sure it is enabled. To check Wi-Fi Direct name and password (pin), print a configuration report by pressing and holding the  Resume/Cancel button until the Ready LED starts blinking, and then release the button
4. On your computer or mobile device, open the Wi-Fi or wireless settings to view the list of available wireless networks.
5. Select your Wi-Fi Direct printer name from the list of networks, and then enter the password to connect to the printer.
6. In a web browser, type 192.168.223.1 into the address bar, and then press Enter.

1. If a login or certificate window displays, complete the information to finish opening the EWS.
   • If a website security certificate displays, click Continue to open the printer homepage.

Now, let us run the wireless setup wizard from here-

Go to Network Tab > Select Wireless

Click on Wireless Setup Wizard > Choose the network you'd want to connect to and enter the password.

Once connected, the printer will have solid light near the wireless symbol.

You can now configure the printer with other devices to print/scan.

Note:  Disconnect the WiFi-Direct connection and switch the computer/phone to your regular network.

I hope this helps! Keep me posted. 

Please click “Accepted Solution” if you feel my post solved your issue, it will help others find the solution. Click the “Kudos/Thumbs Up" on the bottom right to say “Thanks” for helping!