Guidelines
We have new content about printers, Click here to check it out!
Common problems for Connectivity Issues
We would like to share some of the most frequently asked questions about Printer Wi-Fi, Connectivity Issues and Offline Status. Check out this link: HP printer is offline or unavailable.
Locked

‎08-11-2024 11:24 AM

HP Recommended
Product: HP Neverstop Laser MFP 1202w

I have a new WiFi  network at home and I can’t figure out how to connect my printer to it 

Category:
1 REPLY 1

‎08-11-2024 12:11 PM

HP Recommended

General help for new modem but skip down - reset the wifi and watch the video
1 - Restore Wi-Fi setup mode on your HP printer
2 - Wi-Fi connection is lost after router or network settings change
3 - HP Smart help with printer connection.



Reset instructions (does not erase nvram)


Press and hold the Wireless button and the Cancel button at the same time until the power light blinks. The printer restarts and then the Wireless light starts blinking blue, indicating the printer is in Auto Wireless Connect (AWC) setup mode. You can now set up a wireless connection between the printer and your device.



I think it stays in setup mode for 2 hours.


To perform a factory reset of the NVRAM
(Non-Volatile Random Access Memory) on an HP 1202 printer,
follow these steps:

  • Turn off the printer: Press the Power button to turn off the printer.
  • Press and hold the Resume button: While holding down the Resume button, press the Power button to turn on the printer.
  • Continue to hold down the Resume button until the Attention light turns on.
  • Release the Resume button: Once the Attention light turns on, release the Resume button.
  • Print a configuration page: Press the Resume button once. The printer will print a configuration page, indicating that the NVRAM has been reset to factory settings.
  • Verify the reset: Check the configuration page to ensure that the NVRAM reset was successful. It should display default settings.

Please note that performing a factory reset of the NVRAM will erase all settings and preferences, returning the printer to its original factory state. If you have any specific settings or configurations that you need to retain, make sure to note them down before proceeding with the reset.



WiFi connect
https://support.hp.com/us-en/printer-setup/hp-neverstop-laser-mfp-1200-printer-series/22955699/model...




Click here for Full feature software April 2024

LaserJet Reference

Let me know if you have a flex system (WiFi boosters or repeaters) as the setup is much more complicated.

Thank you for using HP products and posting to the community.
I am a community volunteer and do not work for HP. If you find
this post useful click the Yes button. If I helped solve your
problem please mark this as a solution so others can find it
Was this reply helpful? Yes No
Warning
Be alert for scammers posting fake support phone numbers and/or email addresses on the community.
If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.
Didn't find what you were looking for? Ask the community
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.