Printer Not Connecting to Network

[RichSal]

My HP Smart Tank 7300 series working via WIFI on a network. It was working fine. then stopped working. It cannot be seen on the network. When the HP Network Configuration Page is printed, it says that the Networking Capabilities are not available. It proceeds to tell me that the devices built in networking capabilities were disabled when the device was set up. This is not correct as it was operating and then stopped.

[Irfan_06 · Accepted solution]

Hi @RichSal,

Welcome to the HP Support Community.

Thank you for posting your query, I will be glad to assist you.

I see that you are facing an issue with connecting your Printer to the network.

Please follow the steps below to connect your printer to the network again.

1) Uninstall the HP smart app by click on this link, Restart the computer or mobile device to clear possible error conditions.

2) Enable Wi-Fi setup mode: When you turn on your printer for the first time, it is temporarily placed in Wi-Fi setup mode so that it can be discovered during setup. Use the printer control panel to restore Wi-Fi setup mode, and then set up the printer again. Go to Restore Wi-Fi setup mode on your HP printer for more information.

3) Refer to this link to use the HP smart app on your phone/tablet/PC to add a printer.

Note: Enable Bluetooth for an HP Smart app setup: Enable Bluetooth on your computer or mobile device so that HP Smart can detect the printer during the setup.

Please mark this post as “Accepted Solution” if the issue is resolved and if you feel this reply was helpful click “Yes”.

I hope this helps.

Take care and have a great day ahead!

Irwin6

HP Support