Won’t connect to the internet and after pressing signal button flashes 3 times but then nothing

[Alexav5]

Printer no longer connects to the internet. When I press the wireless button it flashes but then nothing happened. Not one bar of signal appears in the small led area..it’s like it disappeared. Didn’t even realize it was a wireless issue and bought more ink as said I had non but it’s because with no connection the machine doesn’t recognize it has ink. The app says cartridge error but there is no internet to it 

[Anand_Andy]

Hi @Alexav5,

Welcome to the HP Support Community

I understand you are facing a blinking light issue with your  HP DeskJet 2630 All-In-One Printer. Not to worry I will help you to get a resolution to resolve the issue.

To assist better:

• Are you able to make a copy?
• Do you have any errors on the tiny display ( E1, E2, E3, Or E4 )?
• Are you using Genuine HP Ink cartridges?
• Are you enrolled in HP Instant Ink Program?

While you respond to that, Let's perform a power drain: 

• With the printer turned on, disconnect the power cord from the rear of the printer and also unplug the power cord from the wall outlet.
• Remove USB cable, if present.
• Wait for 2-3 minutes, press and hold the power button on your printer for about 30 seconds to remove any additional charge.
• Now plug back the power cable straight to a wall outlet without any surge protector or an extension cord (This is important) and then plug back the power cord to the printer.
• Turn on the printer and wait till warm-up period finishes and the printer is idle

Follow the steps mentioned in this document: HP DeskJet 2600 printers - Blinking lights

Restore Wi-Fi setup mode on the printer

• Prepare a printer for a Wi-Fi connection by restoring the Wi-Fi setup mode.
• When the settings are restored, the printer enters Wi-Fi setup mode for about two hours, making it discoverable during the HP software installation.
•  Press and hold the Wireless and Cancel buttons until the Power button flashes, and then wait for the Wireless light to flash.
• Once you restore the network to defaults, then please follow the instructions on this link to connect the printer back to your PC.

Update the printer firmware: 

• Click here to download and install the latest printer firmware from your product
• Click here to know different methods of updating printer firmware.

Hope this helps! Keep me posted. 

Please click “Accepted Solution” if you feel my post solved your issue, it will help others find the solution. Click the “Kudos/Thumbs Up" on the bottom right to say “Thanks” for helping!