Deskjet 6122 Windows 10 driver

[RichardDPC]

Thanks for this.

The USB setting solved my problem. Test print seems good. If only I'd gone to the forum earlier!

[ADZ5]

This worked for me with the 990c, wasn't able to find the "two sided printing" option with the PCL3.

Also it was helpful to know that I needed to use the correct port.

After a some trial and error, I am now able to print normal pages, no extras.  

Thank you to everyone to contributed!  Your comments helped me greatly!

[RichardDPC]

Could you remind me how to load the 990c driver for windows10. Using the PCL class driver I can only print on one side. Does the 990 fix enable doublesided?

thanks for any advice in advance

[Grayv]

This fix worked and will allow me to use up my ink supplies before upgrading my printer for window 10. The printing has a very little distortion. Thicker character but not too bad. Thanks.

[Bob_Headrick]

---

@RichardDPC wrote:

Could you remind me how to load the 990c driver for windows10. Using the PCL class driver I can only print on one side. Does the 990 fix enable doublesided?

thanks for any advice in advance

---

If you already have the printer set up then to change to the Deskjet 990c driver do the following:  from the Devices and Printers directory right click on the HP Deskjet PCL3 Class Driver.  Select Printer Properties, Advanced, New Driver, Next, Windows Update, (wait a few minutes for an update).  When the list repopulates scroll down to HP (not Hewlett Packard or Hewlett-Packard)  for the manufacturer, select the HP Deskjet 990c, Next, Finish.

To enable the duplexer right click on the Deskjet 990c, Printer Properties, Device Settings, Installable OPtions, Two-Sided Printing, Installed, Apply, OK.

[Christie46268]

Bob

For my situation I have to have the two sided printing "not installed" or maybe it is "not enabled" in order to prevent all kinds of extra garbage pages being printed.

Christie

[RichardDPC]

Thanks Bob, this has at last fixed the issue. I just couldnt get the 990c to download onto the printer drivers list. Have a great week-end. I can now get on with mine!!

R

[ark14616]

Once I completely removed the printer and added from scratch,

select port USB001 and the HP Deskjet PCL3 Class Driver everything

works great. Thank you for the information.

[ark14616]

Completely remove the printer and then do the add printer process.

Select the USB001 port and the PCL3 Class Driver (NOT #2). I tried both

and the #2 does go wide. I got what I wanted when I started from scratch.

I tried just changing the driver and it didn't work. No short cuts

unfortunately.

[Neil955i]

Bob, that's so helpful.  Thanks very much!

😄