-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. -
-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. -
- HP Community
- Printers
- Printing Errors or Lights & Stuck Print Jobs
- Deskjet 3000 error code

Create an account on the HP Community to personalize your profile and ask a question
07-10-2018 07:36 PM
When i turn on my printer i get a error code 0X005FBB6 5 mins after and then it spews out some things i printer yesterday and i dont know how to recreate it but i have been using usb instead of wireless for a few days too
07-12-2018 05:49 AM
Hi! @KoolKrafter22, Thanks for stopping by the HP Support Forums!
I understand when you are printing from your printer you are getting an error- 0X005FBB6
Don't worry I'd like to help you out.
Did you make any changes to your printer?
Are you able to make a copy from your printer?
Try few steps recommended below.
In some cases, removing the ink cartridges and resetting the printer can clear the error message.
Turn on the printer.
Wait until the printer is idle and silent before you continue.
Disconnect the USB cable from the rear of the printer. If your printer has a network or wireless connection, leave it connected.
Remove the ink cartridges from the printer.
With the printer turned on, disconnect the power cord from the rear of the printer and from the wall outlet or power strip.
Wait at least 60 seconds.
Plug the power cord back into the wall outlet.
NOTE:
HP recommends connecting the printer power cord directly to a wall outlet.
Reconnect the power cord to the rear of the printer.
Turn on the printer, if it does not automatically turn on.
The printer might go through a warm-up period. The printer lights might flash, and the carriage might move.
Wait until the warm-up period finishes and your printer is idle and silent before you proceed.
Reinsert the ink cartridges, and then close the ink cartridge access door.
If you receive a prompt to print a calibration page, do so.
If you disconnected the USB cable, reconnect it to the rear of the printer.
Try to print.
Also, Please download and run the HP Print and Scan Doctor on your PC and check if it helps.
Refer this article to know more information about using HP print and scan doctor on your PC.
Refer this article to further troubleshoot 0x errors on your printer.
Please mark my post as accepted solution if you feel I have answered your query.
Let me know if this helps!
Have a pleasant day ahead! 🙂
Please click “Accept as Solution” if you feel my post solved your issue, it will help others find the solution.
Click the “Kudos, Thumbs Up" on the bottom right to say “Thanks” for helping!
A4Apollo
I am an HP Employee