Envy 6000 flashing lights

[MPope87]

I just unboxed my new Envy 6000 wireless printer. Plugged up the printer just as instructions stated and green light came on then amber light started flashing and all the lights on the control panel started flashing. No error code was given. Attempted to connect to HP start and it was unable to connect to my printer. I was unable to install ink cartridge because the catridge slots did not move over to the left, they are all the way over to the right. 

[KrazyToad]

@MPope87

Welcome to HP Support Community

I would like to help

Please try these steps. First ensure the printer has the latest Firmware https://support.hp.com/in-en/document/c02919168

Next assign a Manual IP address

1) Obtain the IP address of the printer – You can print a Network Configuration page to obtain the IP address.

2) Type the IP address on your web browser to obtain the printer EWS page on your computer.

3) Go to "Network" tab - General - Select "Network protocols" - Select "Enable IPv4 only" (or similar) - Apply the settings.

4) Go to the “Network” tab – Click on “Wireless (802.11) – Then click on “Network address (IPv4)

5) Click Manual IP

6) If you see a Suggest a Manual IP Address button, click Manual IP address, and the Manual IP addresses are automatically filled out for you.

7) If your page does not have a button to suggest a manual IP address, type the IP address, subnet mask, and default gateway using the numbers shown in the report you printed.

Keep me posted

Thank you

If the information I've provided was helpful, give us some reinforcement by clicking the "Solution Accepted" on this Post and it will also help other community members with similar issue.