cancel
Showing results for 
Search instead for 
Did you mean: 
Common problems for INSTANT INK, HP+ PLANS: INK AND TONER
We would like to share some of the most frequently asked questions about Instant Ink. Check out this link: HP INSTANT INK, HP+ PLANS: INK AND TONER. .
astro3ron2
New member
3 2 0 0
Message 1 of 4
195
Flag Post

HP P2035 attn light comes on after some printing

HP Recommended
HP P2035
Microsoft Windows 10 (64-bit)

HP P2035 attn light comes on after turning printer on. Did a print a test page and light cleared after some printing light comes on again. Why?

3 REPLIES 3
Repairatrooper
Level 13
Level 13
8,613 8,511 891 2,602
Message 2 of 4
Flag Post
HP Recommended

Does it print one page and then error? If so, it is possible that the paper size set on the printer does not match the loaded paper. This condition will cause that error. It is also possible that the pickup solenoid is sticking, this is easily determined if you hear the pickup roller turning continously. This roller should normally only rotate once when picking a page. You can examine the roller for wear by removing the tray and looking at the grey roller in the top middle of the paper tray cavity. It should have fine fingerprint like ridges on it. If it is smooth then the roller needs to be replaced.

If you find the information provided useful or solves your problems, help other users find the solution easier by giving kudos and marking my post as an accepted solution.
I am a volunteer, offering my knowledge to support fellow users, I do not work for HP nor speak for HP.


Was this reply helpful? Yes No
astro3ron2
Author
New member
3 2 0 0
Message 3 of 4
Flag Post
HP Recommended

Repair...  No it just ends up printing two blank sheets and the light comes on. Doing a test print prints the test info and clears the status light.

Was this reply helpful? Yes No
Repairatrooper
Level 13
Level 13
8,613 8,511 891 2,602
Message 4 of 4
Flag Post
HP Recommended

Have you rechecked your driver and program settings? This really sounds like a size mismatch error. Do you get the same behavior printing from different programs? 

If you find the information provided useful or solves your problems, help other users find the solution easier by giving kudos and marking my post as an accepted solution.
I am a volunteer, offering my knowledge to support fellow users, I do not work for HP nor speak for HP.


Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation