Officejet 4650 won't connect, wont print. A question mark to the left of display window wont go away

[gilc1515]

I recently installed a WIFI range extender.

I went through the troubleshooter, reinstalled drivers and software.

Wireless connection via cable modem.

Next to the infi window display there is a question mark that will not go away, I can't print, and can't connect. HELP

[gilc1515]

I also forgot to mention, ,in the troubleshooting, I did the reset, and memory reset, and it did not correct the problem either.

[Riddle_Decipher · Accepted solution]

@gilc1515 Does the copier work as a stand-alone device? If no, Click here to troubleshoot the same.

If the copier works fine and the issue is only related to printing over the wireless network, please ensure the latest printer drivers are installed using this link: Click here

If that's done but it isn't connecting, Please follow the below steps to assign a manual/static IP to resolve your concern:

-Verify in the printer that 'Auto Off/Sleep' is disabled. Use the Embedded Web Server (EWS) by going to the printers IP address in your browsers address bar, click Settings Tab/Auto-Off. --Or use the Printer Assistant, Printer Home Page (EWS). Also, check your Printers Properties.

-If the printer supports and has IPv6 enabled, turn off IPv6 in the printer.

-If needed and you assigned a static IP address, try using 8.8.8.8 for the Preferred DNS server and 8.8.4.4 at the Alternate DNS server. 

-Verify the printer is on the latest firmware by checking with the HP Support site.

In the router: (Refer to your router manual for information) 

Use a fixed wireless channel like 1, 6 or 11, never 'auto', try channel 1 first then the rest. 

Set router to 20Mhz only, or 145Mbps depending on the router. 

Always use WPA2-AES (Personal) encryption, but you can try `mixed' mode. 

Disable WPS and never use it and disable UPnP for the routers security. Nobody can hack your system now and helps with wireless connectivity (if you want to know why search the web).

If you have a dual-band router (2.4Ghz and 5.0Ghz bands), make sure the SSID's are NOT the same, they must be different for all bands, even for any Guest networks.

SSID broadcast must be enabled.

Save all settings. Power off both, wait 2 mins. Power on the router and wait 2 mins. 

Power on the printer and verify it reconnects to the router

You can also refer to the below video for the same. 

Note that, in the video, the interface shown is the Windows interface, but the steps are the same as it done using a web browser. 

And the article may have the title of another printer, but the steps are bound to help resolve your concern as well.

CLICK HERE TO VIEW THE VIDEO.

Let me know how that pans out,

If you feel I was helpful, simply click on Accept as Solution to help the community grow,

That said, I will have someone follow-up on this to ensure you've been helped,

Just in case you don't get back to us within 24 - 48hrs, and have a good day, ahead.