Power supply turn on, no display

[amolaito]

printer display don’t turn on, but power supply light looks ok

[Jay_G24]

Hi @amolaito,

I'd like to help!

I understand that the printer display is blank and will not turn on.

Try the below suggestions-

Solution one: Turn the printer off and then on again

Follow these steps to restart the printer.

1. Press the Power button to turn off the printer.

2. Wait 60 seconds, and then press the Power button to turn on the printer.

Solution two: Plug the printer directly into a wall outlet

Make sure that the printer is properly connected to a suitable power source.

1. Press the Power button to turn off the printer.

2. Disconnect the printer's power cord from any power strips or surge suppressors and then plug it directly into a grounded wall outlet.

3. Press the Power button to turn on the printer, and then try to use the menu to check if the printer control panel is functional.

Solution three: Reset the printer

Follow the steps below to reset the printer.

1. With the printer turned on, disconnect the power cord from the printer.

2. Unplug the power cord from the power source.

3. Wait 60 seconds.

4. Reconnect the power cord to a wall outlet and to the printer.

   NOTE: 

   HP recommends plugging the printer directly into a wall outlet.

 Also, try updating the printer's firmware -HP Printers - Updating or Upgrading Printer Firmware  

If the issue persists, I'd suggest you contact HP in your region regarding the service options for your printer

Hope this helps! Keep me posted. 

And, Welcome to the HP Support Community. 

Please click “Accept as Solution” if you feel my post solved your issue, it will help others find the solution.

Click the “Kudos, Thumbs Up" on the bottom right to say “Thanks” for helping