Printer error message

[Ecksell]

Cartridge previously installed in an other printer. 

NO IT HASN’T BEEN. HELP!

[KrazyToad]

@Ecksell

Are  you using Genuine HP cartridges? Are you using the correct Cartridge for your Printer?

If you are using the correct genuine cartridges, let's try these steps

Remove the cartridges and clean the electrical contacts with a lint-free cloth

Next perform a Printer Reset

(1) Turn the printer on, if it is not already on.
(2) Wait until the printer is idle and silent before you continue.
(3) With the printer turned on, disconnect the power cord from the rear of the printer.
(4) Unplug the power cord from the wall outlet.
(5) Wait at least 60 seconds.
(6) Plug the power cord back into the wall outlet.
 NOTE: HP recommends connecting the printer power cord directly to the wall outlet.
(7) Reconnect the power cord to the rear of the printer.
(8) Turn on the printer, if it does not automatically turn on.
The printer might go through a warm-up period. The printer lights might flash, and the carriage might move.
Wait until the warm-up period finishes and your printer is idle and silent before you proceed
 

Next update the Printer Firmware and put back the cartridges. You can refer to this Link: https://support.hp.com/in-en/document/c02919168

Keep me posted how it goes 😊

If the information I've provided was helpful, give us some reinforcement by clicking the "Solution Accepted" on this Post and it will also help other community members with similar issue.