The information light is staying on

[Denise311]

I have a HP DeskJet 2752e all in one printer, it was printing my work at first, then it just stopped and was printing cover pages, now the information light is staying on and I don't know what to do about it. Please help

[Mans]

@Denise311 

Hello,

Make sure the ink cartridge carriage moves freely. Go to Carriage jam or E3 error.

NOTE: Before you try the following solution, disconnect the USB cable and Ethernet cable from the back of the printer. Make sure that there are no memory cards or thumb drives in the printer.

In order to palliate this incident, please perform a reset of the printer's power supply.

1. Turn on the printer.
2. Before continuing, wait until the printer is idle and silent.
3. Disconnect the USB cable from the back of the printer. If your printer has a network or wireless connection, leave it connected.
4. With the printer turned on, unplug the power cord from the back of the printer and from the wall outlet.
5. Wait at least 60 seconds.
6. Plug the power cord into the outlet.

   NOTE:  HP then recommends reconnecting the printer's power cord directly into a wall outlet.

7. Reconnect the power cord to the back of the printer.
8. Turn on the printer, if it does not automatically make it.
   It is possible that the printer goes through a warm-up cycle. It is also possible that the printer lights blink and the carriage moves.
9. Wait until the preheat cycle and until the printer is idle and silent before continuing.
10. Print a calibration page, if prompted.
11. If you disconnected the USB cable, reconnect it to the back of the product.
12. Try to print.

Don't hesitate to contact us in case of need.

Best regards,