desk jet plus 6475 cartridge problem

[Jayne31]

Deskjet Plus 6475 printer. I replaced my black cartridge as it was empty. now it flashes E and I cannot clear it. I then replaced the colour cartridge as well but the Black cartridge still flashes E. Have switched off switched back on taken then out put them back in. Still the same problem?

[Jay_G24]

Hi @Jayne31,

I'd like to help!

.

I understand you are facing a cartridge problem

Try the below suggestions -

Reset the product

With the printer turned on, disconnect the power cord from the rear of the printer.

Unplug the power cord from the wall outlet.

Wait at least 60 seconds.

Plug the power cord back into the wall outlet.

Reconnect the power cord to the printer.

Turn the printer on. HP recommends plugging the printer directly into a wall outlet.

Clean the ink cartridge and carriage electrical contacts

Remove any debris or buildup from the contacts on the cartridges and in the carriage.

1. Open the door or lid to the cartridge access area. Wait until the carriage stops moving before continuing.

2. Remove the cartridge indicated in the error message from the carriage.

   • Carriages with cartridge latches: Open the latch, and then pull the cartridge up and out of the slot.

     

   • Carriages without cartridge latches: Gently press down on the cartridge to release it, and then pull it out of the slot.

     

3. Holding the cartridge by the sides, remove any protective tape that still might be on the contacts.

   CAUTION: 

   Do not touch the ink nozzles or the copper-colored electrical strip. Touching or trying to remove these parts can result in clogs, ink failure, and bad electrical connections.

   

4. Lightly dampen a lint-free cloth with distilled water, and then wipe the copper-colored contacts on the cartridge.

   

5. Lightly dampen a lint-free cloth or swab with distilled water, and then clean the electrical contacts in the carriage.

   

6. Wait 10 minutes for the contacts to dry, and then reinsert the cartridge into its color-coded slot.

7. Repeat these steps for the other cartridge if it was indicated in the error message.

8. Close the door or lid to the cartridge access area.

   If the error persists, clean the cartridge and carriage contacts a second time.

Try the single-cartridge mode

The printer you own can work in single-cartridge mode, wherein the printer will be able to print with one cartridge in the printer. Which will help us identify if its a cartridge issue or a printhead issue

To try single-cartridge mode follow the below steps:

• remove the black ink from the printer, leave the color in and try printing
• then remove the color ink and, insert the black  in and try printing

try updating the printer's firmware -HP Printers - Updating or Upgrading Printer Firmware  

Refer to -HP DeskJet, ENVY 6000, 6400 Printers - Blinking Lights and Error Codes 

If the issue persists, I'd suggest you contact HP in your region regarding the service options for your printer

Hope this helps! Keep me posted. 

And, Welcome to the HP Support Community. 

Please click “Accept as Solution” if you feel my post solved your issue, it will help others find the solution.

Click the “Yes" on the bottom right to say “Thanks” for helping