cancel
Showing results for 
Search instead for 
Did you mean: 
Common problems for INSTANT INK, HP+ PLANS: INK AND TONER
We would like to share some of the most frequently asked questions about Instant Ink. Check out this link: HP INSTANT INK, HP+ PLANS: INK AND TONER. .
tenthman
New member
1 0 0 0
Message 1 of 2
71
Flag Post

error 3

HP Recommended
Example: Paviliondeskjet 3755 6530

error 3

1 REPLY 1
praveenbv
HP Support Agent
HP Support Agent
4,709 4,707 199 251
Message 2 of 2
Flag Post
HP Recommended

JodiN2021,

 

Welcome to the HP Support Community. I'd be happy to assist you with the  "getting error message on the printer  ".

 

Try the steps below to reset the printer -

 

  1. Open the access door of the ink cartridge.
  2. Now, you got to wait till the carriage becomes idle and silent. Once the carriage becomes idle and silent, you got to continue to the next procedure.
  3. Remove the power cord.
  4. If you got to remove any object or a paper that blocks the carriage path, all you need to do is you got to push the carriage to the right.
  5. Now, close the door of the ink cartridge.
  6. Turn on the printer by re-connecting the power cord.
  • Go through following to ensure that ink cartridges have been correctly installed:

Check if you have placed ink cartridge properly because improper placement could also be the cause of hp deskjet 3755 error.

> Power on the printer.

> Open the access door of ink cartridge.

> Proceed once the carriage becomes silent and idle.

> Release the ink cartridge by gently pressing down. Pull the ink cartridge out of the

Slot.

>Repeat the above steps for other ink cartridge.

>Close the access door of ink cartridge.

  • After above troubleshooting steps, turn on the printer and try to print the page. If the error still persists, you got to continue to the next step.
  • To get rid of the issue, reset the printer with following steps:

> Power on the printer if it is not in On mode.

> Wait till printer becomes idle and silent.

> Once the printer turns on, you got to disconnect the power cord from the printer

rear.

> Wait for 10 seconds.

> Again, connect the power cord to the printer rear.

> If the printer does not get automatically turn on, you need to power on the printer.

> You need to wait until the warm period gets over. It might also happen that printer lights

Flash and carriage move. Try to print, if the error still continues, go to the next

step.

 

Hope this helps! Keep me posted.

 

Please click “Accept as Solution” if you feel my post solved your issue, it will help others find the solution.

Click the “Kudos, Thumbs Up" on the bottom right to say “Thanks” for helping!

Have a great day! 

 

0 Kudos
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation